LARGE = 3/8"

Use keyhole rivet hangers on rivets or hangerless bolts to utilise the maximum strength from the placement.  Gain the maximum height available with the short length of keyhole hangers.  Hangers fit a wide variety of anchors, including; 1/4″, 5/16″, and 3/8″ round or hex head anchors.  Carry a few as lightweight insurance for missing hangers in the backcountry.  Stronger than wire rivet hangers.  Decrease rope drag and increase stability by using a single karabiner to lock the hanger securely in place.  The “wings” inside the 3/8″ hanger allow  just one karabiner to act as a keeper.

Made in the USA.

The 3/8″ fits:

• Most Australian Crags' bolts
• 3/8″ Rawl Spike and Buttonhead anchors
• 1/2″ Powers 5-piece hangerless bolts
• 10mm Fixe hangerless bolts
• 12mm Fixe Triplex hangerless bolts

Weight:   21 grams
Material:  stainless steel
Strength:   2,500 lbf (~ 12kN)

Care:

Finish:  Keyhole Rivet Hangers are made from stainless steel.  This is stainless not stainproof.  If a surface becomes rusty remove rust with scotchbrite or fine abrasive pad.   Remove any moisture from surfaces before storage.  Oil with a good water displacing product (WD-40 or equivalent).  Wipe excess off with a clean dry cloth.  Store in a dry place.   

Shape:  Use a file to remove any burrs that have resulted from heavy use.